346-5016/02 – Machines and Equipment for Additive Technologies (SZAT)
| Gurantor department | Department of Machining, Assembly and Engineering Metrology | Credits | 4 |
| Subject guarantor | Ing. Jiří Hajnyš, Ph.D. | Subject version guarantor | Ing. Jiří Hajnyš, Ph.D. |
| Study level | undergraduate or graduate | Requirement | Compulsory |
| Year | 2 | Semester | summer |
| | Study language | English |
| Year of introduction | 2023/2024 | Year of cancellation | |
| Intended for the faculties | FS | Intended for study types | Follow-up Master |
Subject aims expressed by acquired skills and competences
The aim of the subject is to familiarize students with the design solution of machines and equipment for additive technologies. Students are introduced to several types of 3D printers and finishing equipment. These machines are then analyzed theoretically and practically. After completing the course, the student will be able to perform maintenance and repair of the given printer or device.
Teaching methods
Lectures
Tutorials
Summary
Understanding the functioning of machines and equipment for additive technologies is good preparation for practice. In this subject, the student learns theoretical, but also practical things regarding the construction and operation of 3D printers and their peripherals. Thanks to this, the student is ready to come into practice and thus be ahead of others.
Compulsory literature:
Recommended literature:
SCHELLY, Chelsea, Gerald ANZALONE, Bas WIJNEN a Joshua M. PEARCE. Open-source 3-D printing technologies for education: Bringing additive manufacturing to the classroom [online]. 2015, 28, 226-237. ISSN 1045926X. Dostupné z: doi:10.1016/j.jvlc.2015.01.004
Way of continuous check of knowledge in the course of semester
Project
Test
Active participation
E-learning
Study materials are shared on lms.vsb.cz.
Other requirements
Knowledge of the subjects Basics of additive technologies and Postprocessing in additive technologies.
Prerequisities
Subject has no prerequisities.
Co-requisities
Subject has no co-requisities.
Subject syllabus:
1. Introduction to machines and equipment for additive technologies
2. The FDM method – the construction of printers and their weak points
3. The FDM method – extruder construction for filament production/recycling
4. The SLM method – the construction of printers and their weak points
5. The SLM method – design and principle of the tumbling device
6. The SLS method – the construction of printers and their weak points
7. The SLS method – construction and principle of the blasting device
8. Assignment of a project
9. The SLA method - construction of printers and their weak points
10. The SLA method – construction and principle of the curing station
11. The DED method – the construction of printers and their weak points
12. The DED method - construction and principle of the electrolytic device
13. Final evaluation of the semester.
Conditions for subject completion
Occurrence in study plans
Occurrence in special blocks
Assessment of instruction
Předmět neobsahuje žádné hodnocení.