632-3017/01 – Measurements on vehicles (MV)
| Gurantor department | Department of Materials and Technologies for Vehicles | Credits | 5 |
| Subject guarantor | Ing. Martin Juránek, Ph.D. | Subject version guarantor | Ing. Martin Juránek, Ph.D. |
| Study level | undergraduate or graduate | Requirement | Choice-compulsory type B |
| Year | 2 | Semester | summer |
| | Study language | Czech |
| Year of introduction | 2019/2020 | Year of cancellation | |
| Intended for the faculties | FMT | Intended for study types | Follow-up Master |
Subject aims expressed by acquired skills and competences
Practical introduce students with real measured variables in an experimental vehicle and their storing and evaluation.
Ability to perform measurements of driving conditions using standard and laboratory instrumentation.
Ability to analyze and evaluate multichannel data
Measuring velocity, acceleration, speed, braking force, passive resistors vehicles.
Teaching methods
Tutorials
Project work
Summary
Practical introduce students with real measured variables in an experimental vehicle and their storing and evaluation.
Ability to perform measurements of driving conditions using standard and laboratory instrumentation.
Ability to analyze and evaluate multichannel data
Measuring velocity, acceleration, speed, braking force, passive resistors vehicles.
Compulsory literature:
Recommended literature:
Way of continuous check of knowledge in the course of semester
To obtain a graded credit, it is necessary to obtain 51 or more points from the following activities:
- 2x driving tests with an instrumented vehicle on the VŠB premises
- 1x driving tests with an instrumented vehicle on a test site
- 1x calibration of sensors on the vehicle in the laboratory
- 4x protocols with processing of measured data from driving tests
E-learning
Other requirements
80% attendance at seminars
Prerequisities
Subject has no prerequisities.
Co-requisities
Subject has no co-requisities.
Subject syllabus:
1.Measuring wheel speed (measuring directly on the sensor ABS, reading wheel speed from the CAN bus, conversion of measured pulses to wheel speed and vehicle speed).
2.Measurement of ABS, wheel speed, acceleration, pressure in the brake circuit.
3.Measurement permitted braking force (by TÜV - measuring the force on the pedal and longitudinal acceleration).
4.Measuring braking distance (deceleration from the accelerometer, speed sensors, calculation).
5.Measurement of torque on the semi-axes.
6.Measurement 0-50,100 acceleration from wheel speed and GPS.
7.Measurement of parameters for the virtual differential and skid detection (measuring wheel speed depending on the steering angle, measuring the turning radius of the vehicle depending on the steering angle).
8. Measuring antiskid, wheel speed and their derivatives and reduced performance in a straight line and when turning.
9.Measuring the efficiency of the brakes, wheel speed, acceleration,discs temperature , etc.
10.Measurement of passive resistances, sailing of vehicle.
11.Measuring yaw and its comparison with a turning of the steering wheel, the detection of skid.
Conditions for subject completion
Occurrence in study plans
Occurrence in special blocks
Assessment of instruction