633-0031/02 – Ecotechnics at Forming (NT)
Gurantor department | Department of Materials Forming | Credits | 3 |
Subject guarantor | doc. Ing. Miroslav Greger, CSc. | Subject version guarantor | doc. Ing. Miroslav Greger, CSc. |
Study level | undergraduate or graduate | Requirement | Compulsory |
Year | 3 | Semester | winter |
| | Study language | Czech |
Year of introduction | 1999/2000 | Year of cancellation | 2010/2011 |
Intended for the faculties | | Intended for study types | |
Subject aims expressed by acquired skills and competences
Overview of used forming techniques and procedures and their analysis from the viewpoint of environmental strain. Possibilities environment protection in forming processes. Care for working environment, water, soil and atmosphere. Protection against impacts of noise, vibrations, radiation and radiant heat. Environmentally friendly forming technologies and conditions for their implementation. Reduction of energy intensity of forming. Utilisation of finish forming temperature for subsequent heat treatment. Origination, utilisation and treatment of waste. Overview of legislative acts and directives concerning environmental protection in forging shops, rolling mills, drawing mills and pressing shops.
Teaching methods
Summary
Overview of used forming techniques and procedures and their analysis from the
viewpoint of environmental strain. Possibilities environment protection in
forming processes. Care for working environment, water, soil and atmosphere.
Protection against impacts of noise, vibrations, radiation and radiant heat.
Environmentally friendly forming technologies and conditions for their
implementation. Reduction of energy intensity of forming. Utilisation of finish
forming temperature for subsequent heat treatment. Origination, utilisation and
treatment of waste. Overview of legislative acts and directives concerning
environmental protection in forging shops, rolling mills, drawing mills and
pressing shops.
Compulsory literature:
Bolton, W. Newnes Engineering Materials Pocket Book. 2nd ed. Boston: Butterworth-Heinemann, 1996. 226p.
Recommended literature:
GREGER, M.: Teze jednotlivých přednášek
Way of continuous check of knowledge in the course of semester
Test. Influence technology forging on environment
E-learning
e-learning isn't written
Other requirements
Monitoring source of information and new tendency about influence mechanical working on environment
Prerequisities
Subject has no prerequisities.
Co-requisities
Subject has no co-requisities.
Subject syllabus:
1.Overview of used forming techniques and procedures and their analysis from the viewpoint of environmental strain.
2.Possibilities environment protection in forming processes.
3.Care for working environment, water, soil and atmosphere.
4. Protection against impacts of noise, vibrations, radiation and radiant heat.
5. Environmentally friendly forming technologies and conditions for their implementation.
6. Reduction of energy intensity of forming.
7. Utilisation of finish forming temperature for subsequent heat treatment.
8.Origination, utilisation and treatment of waste.
9. Overview of legislative acts and directives concerning environmental protection in forging shops,
10. Overview of legislative acts and directives concerning environmental protection in rolling mills,
11. Overview of legislative acts and directives concerning environmental protection in drawing pressing
12. Overview of legislative acts and directives concerning environmental protection in pressing
13.Overview of legislative acts and directives concerning environmental protection in extrusion
Conditions for subject completion
Occurrence in study plans
Occurrence in special blocks
Assessment of instruction
Předmět neobsahuje žádné hodnocení.